International Journal of Scientific Engineering and Research (IJSER)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed | ISSN: 2347-3878


Downloads: 0

India | Mechanical Engineering | Volume 8 Issue 1, January 2020 | Pages: 11 - 13


Optimization of Machining Parameter on Vertical Machining Center of FG 250 Casting for Surface Roughness

Sagar S. Chougale, A. N. Chapgaon

Abstract: FG 250 is flange used in water pump which is machined and finished using VMC. Present work focuses on optimization of drilling process parameters of FG 250 flange using taguchi optimization technique. Surface roughness was the response variable investigated. Experimental results indicate that proposed mathematical model suggested adequately describe performance indicator within the limits of factors that are being investigated. Flow rate is the most influencing factor on surface roughness followed speed and feed.

Keywords: FG 250, surface roughness, Anova, S/N ratio



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top