International Journal of Scientific Engineering and Research (IJSER)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed | ISSN: 2347-3878


Downloads: 0

India | Material Science and Engineering | Volume 4 Issue 8, August 2016 | Pages: 67 - 69


Development of Nano-TiO2 by Mechanical Milling

A. Mishra, S. B. Kumar D. Roy

Abstract: This paper reports the results of an investigation aiming at finding what affects the grain size of nano-TiO2 powder during synthesis. Nano-sized TiO2 powders have been prepared by a Mechanical milling method. The crystalline structures and morphologies of the powder have been characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The result shows that the different preparation conditions such as wet, dry and milling time have a lot of influences upon the properties of nano-TiO2 powders. The smallest grain size of TiO2 powder we have obtained is ~12nm by controlling the process conditions.

Keywords: Milling time; Nano-TiO2 powder, XRD, TEM.



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top