International Journal of Scientific Engineering and Research (IJSER)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed | ISSN: 2347-3878


Downloads: 0

India | Dental Science | Volume 5 Issue 2, February 2017 | Pages: 83 - 88


Dental Porcelain (Core) with Improved Fracture Toughness and Microhardness

Indu Raj, Harshakumar K, Sheena .P, Vinodkumar .P

Abstract: To study the effect of different cooling rates after glaze firing on Radius of radial crack, Fracture toughness and Microhardness of Alumina reinforced porcelain. Total 30 porcelain discs reinforced with aluminium oxide of 8mm diameter?0.6mmthickness were prepared. Specimens were divided into three groups, each group containing ten discs. They were positioned at the entrance of the furnace with a temperature of 5930C for ten minutes and then elevated to a non vacuum furnace while the temperature was increased to 9700C at a rate of 500C per minute for glaze firing and each group was cooled at a different rate. After cooling, indentations on each disc were made with a Vickers indenter with a microhardness tester loaded with one kilogram for twenty seconds. Statistical analysis revealed significant differences in fracture toughness of porcelain for each of the cooling rates. The slow-cooled group had significantly lower fracture toughness than the group with medium cooling rate and the group with rapid cooling rate. Highest fracture toughness value was obtained for rapidly cooled group. The highest VMH value was also obtained for the rapidly cooled group.

Keywords: Aluminous porcelain, hardness, firing& fracture toughness



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top